This development is very basic. It provides the GPIO in the form of header. As i will be using this board for rapid development and learning different coding practices.
I designed this board in KiCad – a open source l tool. From schematics and PCB layout is designed in this software suite.
Here are the schematics and PCB layout.
As i don’t have a laser printer i used the free hand sketching of traces. It is a very long and tedious process. After tracing with permanent marker and letting it dry it for few minutes. I etched this PCB in ferric chloride solution. I use very diluted solution, few grams of ferric chloride in around 200 ml water.
Total Etching time is around 40 minutes, After the board has been etched it needs to be cleaned thoroughly. I used utensil cleaning powder for that. And rinsed the board under water. And then let it air dry for few minutes.
The development is created. But there are few issues that came while testing the board. When i tested the board the chip does not responds. While checking for shorts or no connection on the PCB. I found that capacitor is not blocking the alternating signal. rather it is showing a short. So i had to change the 22pf capacitor with a new one and the board now works perfectly fine.